Challenges of bent IG

Options for achieving lower U-factors
By Joe Erb and Tracy Rogers
May 4, 2010
FABRICATION : TECHNOLOGY

Click on the attached PDF to read the article.

Editor’s note: This article is part one of a two-part series, first presented as a paper at the Glass Performance Days Conference in Finland in 2009, www.gpd.fi. Part two will explain how to choose the proper IG spacer and sealant, as well as examine production procedures unique to bent IG fabrication. This article has been edited for Glass Magazine.

Attached File:
FactoryFloor.pdf

Joe Erb is product manager, Edgetech I.G., and Tracy Rogers is technical director, Edgetech I.G., Cambridge, Ohio. Write them at jerb@edgetechig.com and tgrog@earthlink.net, respectively.